SV-iS7 User Manual - Inverter Drive Supermarket

Operating
Command
Frequency
Chapter 7 Basic Functions
7.1.20 Selection of second operating method (By-pass operation)
You can enter the frequency, operating command and torque reference as the second set values by using the multi-
function input terminal. This can be applied in case of remote operation using the communication option or operation
in the main body of the inverter with the remote braking stopped.
Group Code No. Function Display Setting Display Unit
06 Cmd Source 1 Fx/Rx-1 -
DRV 07 Freq Ref Src 2 V1 -
08 Trq Ref Src 0 Keypad-1 -
04 Cmd 2 nd Src 0 Keypad -
BAS 05 Freq 2nd Src 0 KeyPad-1 -
06 Trq 2 nd Src 0 Keypd-1 -
IN 65~75 Px Define 15 2nd Source -
Select one of the multi-function terminals between IN-65 ~ IN-75 of the terminal block input group.
BAS-04 Cmd 2nd Src, BAS-05 Freq 2nd Src: With the multi-function input terminal set as 2nd Source ON, the
inverter can operate with the values set at BAS-04 and 05 instead of the values set at DRV-06 and DRV-07.
BAS-06 Trq 2nd Src: With the multi-function input terminal ON, you can enter the torque reference in the method
selected in BAS-06 instead of the method chosen in DRV-08. DRV-08 and BAS-06 are displayed only after the control
mode(DRV-09) is set as sensorless vector or vector control mode and the torque mode(DRV-10) is set as Yes.
Caution
With the multi-function input terminal set as the 2 nd source and turned ON, the operation status
changes because the frequency command, operating command and torque reference all turn into
2 nd commands. Therefore make sure you check whether 2 nd commands are rightly set before
inputting the multi-function terminal.
ADV-33
ADV-32
ADV-31
ADV-30
ADV-29
ADV-28
10V
V1
(Voltage Input)
0 20mA I (Current Input)
: Frequency
Declining
: Frequency
Rising
7-30