SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 8 Applied Functions
8.1.5 Safe operation mode (if you want to limit operation through Terminal Input)
Group Code No. Function Display Setting Display Setting Range Unit
ADV
8-8
70 Run En Mode 1 DI Dependent - -
71 Run Dis Stop 0 Free-Run 0~2 -
72 Q-Stop Time - 5.0 0~600 sec
IN 65~75 Px Define 13 Run Enable 0~48 -
This is the function of setting the operating command for it to be effective by using the multi-function input terminal.
Group Code No. Function Display Code description
IN 65~75 Px Define
ADV
70
71
72
n (P4)
Operation
command (P1)
Run
En Mode
Run
Dis Stop
Q-Stop
Time
ADV-71
(0:setting Free-Run)
selects the terminal to operate at No. 13 Safe Operation Mode
Run Enable among the multi-function input terminals.
(if setting only multi-function terminals as Run Enable, Safe
Operation is not active)
if setting at No. 1 DI Dependent, the operating commands it
identified through the multi-function input terminal.
Set at No. 0 Always Enable, the safe operation mode is not active.
sets the motions of the inverter when the multi-function input
terminal set at safe operation mode is OFF.
0 : Free-Run
Blocks the inverter output when the multi-function terminal is OFF.
1 : Q-Stop
Decelerates at the decelerating time(Q-Stop Time) used in safe
operation mode. Operation resumes after the operation command
is input once again even if the multi-function terminal is ON.
2 : Q-Stop Resume
Decelerates at the decelerating time(Q-Stop Time) of safe
operation mode. Normal operation resumes when the multifunction
terminal is input again with the operating command ON.
If ADV-71 Run Dis Stop is set at No.1 Q-Stop or No.2 Q-Stop
Resume, the decelerating time is set.
ADV-71
(1:setting Q-Stop)
ADV-71
(1:setting Q-Stop Resume)