SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 8 Applied Functions
AUT-01 Auto Mode : selects the type of auto sequence operation.
0 : Auto-A
This is the operating method of proceeding with the automatically set steps if the terminal set at SEQ-L or SEQ-M is
input among the multi-function terminal function items.
1 : Auto-B
You can proceed with steps every time when a terminal set as Go-Step is input and the terminal set at SEQ-L or
SEQ-M is input. For the motions of each, see the figure below.
AUT-02 Auto Check : sets the time when the terminals set as SEQ-L and SEQ-M are simultaneously input. If one
of the two terminals is input, another terminal is waited for to be input for the set period of time. If another terminal is
input within the set period of time, they are treated as being input at the same time.
AUT-04 Step Number : sets the number of steps of sequence operation. The frequency, Acc/Dec, steady speed
and direction of each step are displayed according to the set number of steps.
AUT-10 Seq 1/1 Freq : displays the operating frequency of step 1. The first 1 of 1/1, which is displayed on the
message, shows the sequence type and the second 1 shows the number of steps. For example, if the terminal set
as No. 42 SEQ-2 among the multi-function input terminal functions is input, operation starts from the frequency set
at Seq 2/1 Freq.
AUT-11 Seq 1/1 XcelT : sets the Acc/Dec time and the time it takes to move to the frequency set at AUT-10.
AUT-12 Seq 1/1 StedT : sets the time of steady speed operation at the frequency set at AUT-10.
AUT-13 Seq 1/1 Dir : sets the direction of rotation.
8-52
Output
Frequency
Px(SEQ-L)
Px(SEQ-
M)
Output
Frequency
Px(SEQ-L)
Px(Go-
Step)
Ouput
Frequency
AUT-10
AUT-11 AUT-12
Sequence
1
AUT-14
AUT-15 AUT-16
Auto-A
Auto-B
AUT-19
AUT-18
Sequency
2
Forward
AUT-13
AUT-17
AUT-21
Reverse