SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 7 Basic Functions
6) Frequency setting by Encoder Option Card (If you want use pulse input to frequency command)
Group Code No. Function Display Setting Displayed Setting Frequency Unit
DRV 07 Freq Ref Src 7 Encoder - -
IN 01 Freq at 100% - 60.00 0.00~Max. Freq. Hz
APO
01 Enc Opt Mode 2 Reference 0~2 -
04 Enc Type Sel 0 - 0~2 -
05 Enc Pulse Sel 2 A 0~2 -
06 Enc Pulse Num - - 10~4096 -
09 Pulse Monitor - - - kHz
10 Enc Filter - 10 0~10000 msec
11 Enc Pulse x1 - 0.0 0~100 kHz
12 Enc Perc Y1 - 0.00 0~100 %
13 Enc Pulse x2 - 100.0 0~100 kHz
14 Enc Perc y2 - 100.00 0~100 %
If you mount the encoder option card on the main body of the inverter, the code is displayed from APO-01.
APO-01 Enc Opt Mode, APO-05 Enc Pulse Sel: Select No.2 Reference for APO-01 in order to set the frequency with
the encoder. Set APO-05 at No.2 A.
APO-04 Enc Type Sel, APO-06 Enc Pulse Sel: inputs the output method and number of pulses in harmony with the
encoder specification.
APO-10 Enc Filter ~ APO-14 Enc Perc y2: sets the filter time constant and minimum and maximum input frequency of
the encoder input. The output frequency corresponding to the encoder input frequency is the same as that of voltage (V1)
or current (I1) input.
APO-09 Pulse Monitor: displays the frequency of the pulse which is input when APO-01 Enc Opt Mode is set as
Reference.
7) Frequency setting by RS-485 Communication: Int 485
Group Code No. Function Display Setting Displayed Setting Frequency Unit
DRV 07 Freq Ref Src 6 Int 485 - -
01 Int485 St ID - 1 0~250 -
0 ModBus RTU 0~2 -
02 Int485 Proto 1 ModBus ASCII 0~2 -
COM
04 Int485 BaudR
2
3
LS Inv 485
9600
0~2
1200~38400
-
bps
0 D8 / PN / S1 0~3 -
07 Int485 Mode
1
2
D8 / PN / S2
D8 / PE / S1
0~3
0~3
-
-
3 D8 / PO / S1 0~3 -
7-8