SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 8 Applied Functions
2) Jog Operation by Terminal Block 2
Group Code No. Function Display Setting Display Setting Range Unit
DRV
11 JOG Frequency - 10.00 0.5~maximum frequency Hz
12 JOG Acc Time - 20.00 0~600 Sec
13 JOG Dec Time - 30.00 0~600 Sec
65~75 Px Define 46 FWD JOG - -
IN
65~75 Px Define 47 REV JOG - -
*Px : P1~P8, P9~P11(Option)
Jog operation 1 is available when the operating command is input but jog operation 2 is available with only terminals
set as the forward jog (FWD JOG) or reverse jog (REV JOG).
The priority order of terminal input (dwell, 3-wire, up/down), frequency and Acc/Dec time and so on during jog
operation is the same as jog operation 1 and if an operating command is given during jog operation, operation
continues at the jog frequency.
When setting
multi-key jog
REV key
FWD key
P1
P5
CM
FX
JOG
DRV-12 (Acc time)
DRV-11 (Jog frequency)
DRV-13 (Dec time)
3) Jog Operation by Keypad
Mode Group Code No. Function Display Setting Display Setting range Unit
CNF - 42 Multi-Key Sel 1 JOG Key - -
PAR DRV 06 Cmd Source 0 Keypad 0~5 sec
*Px : P1~P8, P9~P11(option)
Set code 42 of CNF mode at 1 JOG Key and DRV-06 of PAR mode at 0 Keypad. If you press multi key, the symbol J at
the top of the screen changes into J and then keypad jog operation becomes available. If you keep pressing FWD or
REV keys, it decelerates at jog frequency(DRV-11 JOG Frequency). Otherwise it stops.
The Acc/Dec time it takes to reach jog operation frequency is set in DRV-12 and DRV-13.
DRV-11
8-5