SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 6 How to use Keypad
6.1.4 Group shift
You can make inter-group shift by using Left/Right keys after shift to Parameter Mode or User/Macro Mode using the
Mode key.
1) Group Shift in Parameter Mode
If you press Right key in the Parameter Mode, the display changes as follows. If you press Left key, the display order
will be reversed.
6-10
Group Movable by MODE Key
Ex) Monitor->Parameter
Parameter
User&Macro
MON T/K N STP 0.00Hz
PAR DRV N STP 0.
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Cmd Torque
PAR BAS N STP 0.00Hz
00 Jump Code
20 CDE
01 Aux Ref Src
None
02 Cmd 2nd Src
Fx/Rx-1
PAR ADV N STP 0.00Hz
00 Jump Code
24 CODE
01 Acc Pattern
Linear
02 Dec Pattern Linear
Drive
User
Basic Function
Macro 1
Advanced Function
Control
- Power on, a display emerges as shown on the left. The present mode is the
monitor mode.
Macro 2
- Press Mode key once.
- You have shifted to Parameter Mode.
- The drive group of Parameter Mode is being displayed.
- Press Right key once.
- You shift to Basic Function Group(BAS).
- Press Right key once.
Input Terminal
- You shift to Advanced Function Group(ADV).
- Press Right Shift key 7 times.
Output Terminal
Communication
Application Option Card
Application
Protection
Movable left/right Key in
Parameter Group
Ex) Drive->Basic Function