SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 7 Basic Functions
2) Terminal Block operating command 1 : Fx/Rx-1
Group Code No. Function Display Setting Display Setting Range Unit
DRV 06 Cmd Source 1 Fx/Rx-1 - -
65~75 Px Define 1 FX - -
IN 65~75 Px Define 2 RX - -
88 Run On Delay - 1.00 0.00~100 sec
*Px : P1~P8, P9~P11 (option)
Set DRV Group 06 at Fx/Rx-1. Select the terminal used for FX and RX operating commands among multi-function
terminals P1~P11 and set the function of the appropriate terminal of IN 65~75 at FX and RX. It stops if the FX and RX
terminals are ON or OFF at the same time.
IN-88 Run On Delay: Operation starts after the set time, too when the FX or RX terminal is input. It can be used where
operation start synchronization with an outside sequence is necessary.
3) Terminal Block operating command 2 : Fx/Rx-2
Group Code No. Function Display Setting Display Setting Range Unit
DRV 06 Cmd Source 2 Fx/Rx-2 - -
IN
FX
RX
65~75 Px Define 1 FX - -
65~75 Px Define 2 RX - -
88 Run On Delay - 1.00 0.00~100 sec
*Px : P1~P8, P9~P11 (option)
FX terminal is used for operating command and RX terminal is for selecting the rotation direction. Set DRV Group 06
at Fx/Rx-2. Select the terminal used for FX and RX operating commands among multi-function terminals P1~P11 and
set the function of the appropriate terminal of IN 65~75 at FX and RX.
IN-88 Run On Delay: Operation starts after the set time, too when the FX or RX terminal is input. It can be used
where operation start synchronization with an outside sequence is necessary.
Frequency
FX
RX
Frequency
7-12