SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 8 Applied Functions
1) Preparation before Starting
Separate the load connected to the motor axis.
Motor parameter input : enter the following values shown on the motor plate.
DRV-14 Motor Capacity(motor capacity)
BAS-11 Pole Number(number of poles)
BAS-12 Rated Slip(rated slip)
BAS-13 Rated Curr(rated current)
BAS-15 Rated Volt(rated voltage)
BAS-16 Efficiency(efficiency)
2) Check whether the encoder option card is mounted on the main body of the inverter.
Set the encoder option mode(APO-01) at No.1 feedback and input the following information according to the specification
of the encoder.
APO-04 Enc Type Sel: select signal delivery method of encoder. Set with instruction manual of encoder.
According to specifications of encoder, select one out of Line Driver(0), Totem or Com(1), and Open Collect(2).
APO-05 Enc Pulse Sel: set the way of encoder output pulse.
In case of (A+B) of NO.0, select forward operation,
In case of –(A+B) of NO.2, select reverse operation. Select NO.1, select frequency reference for setting.
APO-06 Enc Pulse Num: input the number of pulse per rotation.
Group Code No. Function Display Setting Display Setting Range Unit
BAS 20 Auto Tuning 3 Enc Test 0~4 -
01 Enc Opt Mode 1 Feed-back 0~2 -
04 Enc Type Sel 0 Line Driver 0~2 -
APO 05 Enc Pulse Sel 0 (A+B) 0~2 -
06 Enc Pulse Num - 1024 10~4096 -
08 Enc Monitor - - - -
APO -01 Enc Opt Mode: Set as No. 1 feedback.
APO -04 Enc Type Sel: Set the method to deliver a signal. Set it right, referring to the manual. Select one out of Line
Driver(0), Totem or Com(1), Open Collect(2).
APO-05 Enc Pulse Sel: set the way of encoder output pulse.
In case of (A+B) of NO.0, select forward operation,
In case of –(A+B) of NO.2, select reverse operation. Select NO.1, select frequency reference for setting.
APO-06 Enc Pulse Num: input the number of pulse per rotation.
APO-08 Enc Monitor: convert encoder output to the number of motor rotation and write in unit, Hz or rpm.
8-28