SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 6 How to use Keypad
2) Parameter setting in other modes and groups
This gives an example of changing frequency in the Drive Group of Parameter Mode. You can do so too in other
modes or groups.
6-16
PAR DRV N STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Cmd Torque
0.0 %
PAR DRV N STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Cmd Torque
0.0 %
PAR DRV N STP 0.00Hz
01 Cmd Frequency
0.00 Hz
0.50 ~ 60.00 Hz
D:0.00 C:0.00
PAR DRV N STP 0.00Hz
01 Cmd Frequency
10.00 Hz
0.50 ~ 60.00 Hz
D:0.00 C:0.00
PAR DRV N STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
10.00 Hz
02 Cmd Torque
0.0 %
- This is the initial display of Parameter Mode.
- Press Down key.
- You have shifted to 01 frequency setting code.
- Press PROG.
- The cursor flashes so that you can enter frequency.
- If you want to set the frequency at 10Hz, move the cursor to the desired place
using Left/Right keys.
- Enter 10Hz using Up key and press PROG.
- The desired frequency has been changed to 10Hz.