SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 6 How to Use Keypad
1) Parameter mode
Mode Display Description
Has functions necessary for operation including
Drive group DRV frequency/acceleration/deceleration time setting and operation
command selection, etc.
Basic group BAS
Can set the basic functions such as the motor parameter and sequential
frequency, etc.
Advanced function group ADV
Can set the acceleration/deceleration pattern and frequency control
function, etc.
Control function group CON Can set functions related to sensorless and vector control.
Input terminal function
group
IN
Can set functions related to the inverter input terminal block including
multi-function digital input and analog input.
Output terminal function
group
Communication function
group
OUT
COM
Can set the inverter output terminal block functions such as the relay
and analog output.
Sets the functions related to built-in 485 communication and
communication option card in such a case.
Application function group APP Sets functions such as PID control and auto sequence operation.
Auto Sequence run group AUT
Application option group APO
This group is displayed if Auto Sequence Group in APP is selected and
sets the functions necessary for auto sequence operation.
Sets functions related to the encoder option and PLC option card, if
they are used.
Protection group PRT Can set functions for protecting the motor and inverter.
Motor 2 function group
(Motor 2)
M2
This group is displayed if you select Motor #2 among the multi-function
input terminal functions and sets functions related to Motor #2.
2) User& Macro mode
Group Display Description
Of the function items of each group of the parameter mode, the items
User group USR
that need to be monitored or that are frequently set by the user are
grouped and displayed. It is registered by using the multi-function key
of the keypad.
The functions necessary for the inverter according to the load type can
be grouped and selected at the time of delivery from the factory. If the
Macro group MCx user selects a desired operation type, the groups displayed in MC1 or
MC2 are shown. You can select them in CNF Mode. For more details,
see 8-48 page, 8.1.31 Addition to Macro group.
6-7