SV-iS7 User Manual - Inverter Drive Supermarket

27 : Torque Dect
Active if the torque, with the control mode set as sensorless or vector, is below the following levels.
Group
Code
No.
Function
Display
DRV 09 Control Mode
OUT
Chapter 9 Monitor Functions
Initial Setting Unit
3
~
4
Sensorless-1,
Sensorless-2,
Vector
59 TD Level - 100.0 %
60 TD Band - 5.0 %
28 : Timer Out
This is a function of activating the contact point output after a certain period of time using the multi-function terminal
block input.
Group
Code
No.
Function Display Initial Setting Unit
IN 65~72 Px Define 39 Timer In -
OUT
55 TimerOn Delay - 0.00 Sec
56 TimerOff Delay - 0.00 Sec
32 : ENC Tune
Produces warning by releasing contact point output in case of auto tuning if there is no encoder board or APO-01
Enc Opt Mode is not set as Feed-back.
33 : ENC Dir
Produces warning by releasing contact point output in case of auto tuning if the encoder has misdistribution although
the encoder board has been mounted and APO-01 Enc Opt Mode is set as Feed-back.
-
9-15