SV-iS7 User Manual - Inverter Drive Supermarket

2) Code shift (function Items) in other modes and groups
Chapter 6 How to Use Keypad
Using Up and Down keys: The following figures give an example of shifting the code by using Up and Down keys in
DRV and BAS of Parameter Mode. Code shift in other modes are the same.
MON T/K N STP 0.00Hz
PAR DRV N STP 0.00Hz
00
00
Jump
Jump
Code
Code
9 CODE
01 Cmd Frequency 1
0.00 Hz
02 Acc Time
20.0 sec
PAR DRV N STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
01 Cmd Frequency 0.00 Hz
0.00 Hz
02 Acc Time
20.0 sec
PAR BAS N STP 0.00Hz
00 Jump Code
20 CODE
01 Aux Ref Src
None
04 Cmd 2nd Src
Fx/Rx-1
3) How to Shift in Jump Code
- Power on, the display emerges as on the left. The present mode is Monitor
Mode(MON).
- Press Mode key once.
- The display shows DRV of Parameter Mode. If DRV is not displayed, press Mode
key until DRV emerges or press ESC once.
- If you press Down key, you will shift to code No. 0 in DRV of Parameter Mode as
shown on the left.
- Press Right key once.
- You shift to BAS of Parameter Mode.
- You can shift the code by using Up or Down key.
In groups of Parameter Mode and User/Macro Mode, there is Jump Code Entry item for shift to the code of each
group. If the code number is high, you can shift faster than by using Up and Down keys. The following figures give an
example of shift to code number 09 of DRV.
PAR DRV N STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
01 Cmd Frequency 0.00 Hz
0.00 Hz
02 Acc Time
20.0 sec
PAR DRV N STP 0.00Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Acc Time
20.0 sec
- Check that code number 00 is displayed in the initial display of DRV of
PAR(Parameter Mode).
- Press Program key(PROG).
- The cursor flashes so that you can enter the code number as on the left.
6-13