SV-iS7 User Manual - Inverter Drive Supermarket

8.1.28 Parameter initialization
Chapter 8 Applied Functions
Group Code No. Function Display Initial Setting Display Unit
CNF 40 Parameter Init 0 No -
The parameter changed by the user can be initialized to the default value set at the time of delivery. This function
can initialize the data of all groups or selected groups.
Initialization is not available in case of a trip or during inverter operation.
1 : All Groups
All the data are initialized. If you select No. 1 All Groups and press PROG, initialization starts and when initialization
finishes, No. 0 No is displayed.
2 : DRV ~ 13 : M2
Initialization of each individual group is available. If you select the desired group and press PROG, , initialization starts
and when initialization finishes, No. 0 No is displayed.
8.1.29 Parameter view lock and Key lock
1) Parameter Mode View Lock
Group Code No. Function Display Setting Display Unit
CNF
50
51
View Lock Set
View Lock PW
-
-
Unlocked
Password
-
-
The user can set the PAR mode so that it is not viewed using a password on the keypad. In this case, all
modes(CNF mode, user mode, macro mode, trip mode) but the parameter mode(PAR) are always viewed.
CNF-51 View Lock PW : Registers the password to use for parameter mode view lock. For setting, see the
following procedure.
Procedure Description
- If you press PROG key in CNF-51 code, the previous password registration display is
viewed. The default value is 0. When you register for the first time, enter 0.
- If there is a previous password, register it.
1
- If the entered password is the same as the previous password, a display emerges in
which you can register a new password.
- If the entered password is different from the previous password, the previous password
registration display continues to viewed.
2 - Register a new password.
3 - When registration is completed, CNF-51 View Lock PW is displayed again.
CNF-50 View Lock Set : If you enter the registered password with the view lock unlocked, “Locked” is displayed
and the parameter group is not to be viewed on the keypad. If you enter the password again, “Unlocked” is viewed
and if you move with the mode key, the parameter mode is displayed.
8-45