SV-iS7 User Manual - Inverter Drive Supermarket

8.1.30 Addition to User Group (USR Grp)
Group Code No. Function Display Initial Setting Display Unit
CNF
42 Multi-Key Sel 3 UserGrp SelKey -
45 UserGrp AllDel 0 No -
Chapter 8 Applied Functions
You can group data you have chosen from each group of the parameter group and change them. You can register
up to 64 parameters in the user group.
CNF-42 Multi-Key Sel : Selects No. 4 UserGrp SelKey among the functions of the multi-function keys.
If you do not register user group parameter, user group(USR Grp) will not appear even though multi-function key is
set to UserGrp SelKey.
1) How to Register Parameter in USR Grp
Procedure Description
If you select 4.UserGrp SelKey in CNF Mode Code 42, is
1
displayed at the top of the screen.
Go to the parameter you want to register in PAR Mode and press
MULTI Key. For example, If you press MULTI Key in Cmd Frequency,
which is DRV Group Code 1, you will see the following display.
2
3
4
5
Description of the Display
1 : The group and code number of the parameter to register
2 : Name of the parameter to register
3 : Code No. to register in the user group(if you press PROG/ENT Key
in 40, it will be registered in code 40 of the user group)
4 : Information on the parameter already registered in code 40 of the
user group
5 : Setting range of the user group (0 is for withdrawal of setting)
You can set No. 3 in the display above. You can register by selecting
the desired code no. and press PROG/ENT.
If the value changed at No. 3, the values displayed in No. 4 change
too. That is, No. 4 displays the information on the registered
parameters and if nothing is registered with the desired code number,
Empty Code is displayed. 0 is for withdrawal of setting.
The parameters registered as above are registered in the user group
of U&M Mode. (When necessary, parameters can be registered
redundantly. For example, a certain parameter can be registered in
Code 2, Code 11….and so on)
8-47