SV-iS7 User Manual - Inverter Drive Supermarket

Chapter 8 Applied Functions
2) How to Delete Individual Parameters Registered in User Group (USR Grp)
Procedure Description
8-48
If you select 4.UserGrp SelKey with the Multi-Key in CNF Mode Code
1
42, will be seen at the top of the display.
Move the cursor to the code you want to delete in U&M Mode USR
2
Group.
3 Press MULTI Key.
4 You are asked whether to delete.
5 Press YES and then PROG/ENT Key.
6 Deletion is completed.
CNF-25 UserGrp AllDel : If you select No. 1 Yes, all the parameters registered in the user group are deleted.
8.1.31 Addition to Macro Group
Group Code No. Function Display Initial Setting Display Unit
CNF 43 Macro Select 0 None -
If you select the application load, the related function is displayed so that the inverter selects it and it can be
changed in the macro group.
CNF-43 Macro Select : This is the function that enables you to easily set by combining various application
functions. MC1(DRAW function) or MC2(traverse function) group is displayed at User & Macro(U&M) on two
functions DRAW and traverse functions
This function is provided by the inverter. The user cannot add or delete the function items included in the macro but
data can be changed in the macro group.
Please refer to 8.1.37 Traverse operation function for trip bus.
Draw function is one of open loop tension controls to maintain tension of materials stuck, using speed difference of
motor which is operating by ration for main commands
For more details, please refer to chapter, 8.1.1, Override frequency setting using auxiliary frequency command
8.1.32 Easy start
Group Code No. Function Display Initial Setting Display Unit
CNF 61 Easy Start On 1 Yes -
CNF-61 Easy Start On : If you set this code at Yes, ‘All’ is selected in CNF-40 Parameter Init for all the parameters
of the inverter to be initialized and Easy Start is launched when power is Off/On first.