Rexroth Tightening System 350 System Documentation - Rhino ...

More documents

Recommendations

Info

108/316 Bosch Rexroth AG | Tightening Technology 7 Data Services7.2 Ethernet communicationTo configure the Ethernet interface:1. In the BS350 operating system, click on System → Tightening channel configuration.2. Double click on the line X7E1 to open the associated parameters dialog.Figure 7–12:Ethernet interface configurationFigure 7–13:Ethernet interface configurationNoteThe data needed for configuration is determined by the network administrator. Modifications to thesecould influence the entire network or even close the connection.System 350 | 3 608 878 040/05.2008
7 Data Services Tightening Technology | Bosch Rexroth AG 109/3167.2 Ethernet communication– IP addressThe IP address (IP = Internet protocol) is assigned by the network administrator. It identifies the participantduring data exchange.– Subnet maskThe subnet mask contains information on the network configuration (size of the address area) and isdetermined by the network administrator.– Host nameThe host name is the name used to address the Ethernet participant (the tightening system's controllerunit in this case).– DNSThe task of the Domain Name Service (DNS) is to assign logical participant names to unique IP addresses.This information is provided by the DNS server. Here, the DNS server is entered with its IPaddress which enables the controller to process the name (an IP address is derived from the name) 1) .– Domain nameThe domain name is the same for all of the Ethernet participants. A participant's complete, logicalname is “Tighteningsystem.Domainname” 1)) .– GatewayThe gateway creates the outside connection. If a participant is not found in the network or is a stranger,then the data packages are sent to the gateway. The gateway then searches for the receiver andforwards the data packages.Saving the configuration in the tightening systemThe interface configuration is only valid after the settings have been sent to the tightening system.7.2.6.2 Testing the Ethernet connectionNote You can only test the Ethernet connection if the interface has been configured (see page 107).Some typical test functions to set up an Ethernet connection have been implemented in the tighteningsystem's operating system. These functions are summarized in the menu under System test → Ethernet.Figure 7–14:Testing the Ethernet connection1) A DNS server and domain name are only necessary if participants' are to be addressed on the controllerwith their host names and not IP addresses.System 350 | 3 608 878 040/05.2008
Page 1 and 2:
Rexroth Tightening System 350System
Page 3 and 4:
ContentsSchraubtechnik | Bosch Rexr
Page 5 and 6:
ContentsSchraubtechnik | Bosch Rexr
Page 7:
1 About This DocumentThis chapter c
Page 10 and 11:
10/316 Bosch Rexroth AG | Tightenin
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
F PAF KRF S38/316 Bosch Rexroth AG
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59: 58/316 Bosch Rexroth AG | Tightenin
Page 100 and 101: 100/316 Bosch Rexroth AG | Tighteni
Page 158 and 159:
158/316 Bosch Rexroth AG | Tighteni
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Page 172 and 173:
Page 174 and 175:
OKNOK191781624FGC1C3C2CS351174/316
Page 176 and 177:
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190 and 191:
Page 192 and 193:
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Page 218 and 219:
Page 220 and 221:
Page 222 and 223:
Page 224 and 225:
Page 226 and 227:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
Page 268 and 269:
Page 270 and 271:
.270/316 Bosch Rexroth AG | Tighten
Page 272 and 273:
Page 274 and 275:
Page 276 and 277:
Page 278 and 279:
Page 280 and 281:
Page 282 and 283:
Page 284 and 285:
Page 286 and 287:
Page 288 and 289:
Page 290 and 291:
Page 292 and 293:
Page 294 and 295:
Page 296 and 297:
Page 298 and 299:
Page 300 and 301:
Page 302 and 303:
Page 304 and 305:
Page 306 and 307:
Page 308 and 309:
Page 310 and 311:
Page 312 and 313:
Page 314 and 315:
Page 316:
Bosch Rexroth AGElectric Drives and
show all

Rexroth Tightening System 350 System Documentation - Rhino ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?