Rexroth Tightening System 350 System Documentation - Rhino ...

34/316 Bosch Rexroth AG | Tightening Technology 4 Safety Instructions for Rexroth Tightening Systems4.4 Channel-Specific Notes4.4.6 Protection During Handling and MountingIn unfavorable conditions, handling and mounting certain parts and components in an improper way cancause injuries.4.4.7 Battery SafetyCAUTIONRisk of injury by improper handling! Bodily injury by bruising, shearing, cutting,hitting!⇒ Observe the general construction and safety regulations on handling and mounting.⇒ Use suitable devices for mounting and transport.⇒ Avoid jamming and bruising by appropriate measures.⇒ Always use suitable tools. Use special tools if specified.⇒ Use lifting equipment and tools in the correct manner.⇒ If necessary, use suitable protective equipment (for example safety goggles, safety shoes, safetygloves).⇒ Do not stand under hanging loads.⇒⇒Immediately clean up any spilled liquids because of the danger of skidding.Lay cables and lines observing the admissible bending radius so that they cannot be damagedand no one can trip over them.Batteries consist of active chemicals enclosed in a solid housing. Therefore, improper handling can causeinjury or material damage.CAUTIONRisk of injury by improper handling!⇒ Do not attempt to reactivate low batteries by heating or other methods (risk of explosion and cauterization).⇒ Do not recharge the batteries as this may cause leakage or explosion.⇒ Do not throw batteries into open flames.⇒ Do not dismantle batteries.⇒ Do not damage electrical components installed in the equipment.NoteEnvironmental protection and disposal! The batteries contained in the product are considered dangerousgoods during land, air, and sea transport (risk of explosion) in the sense of the legal regulations. Disposeof used batteries separate from other waste. Observe the local regulations in the country of assembly.System 350 | 3 608 878 040/05.2008