Rexroth Tightening System 350 System Documentation - Rhino ...

160/316 Bosch Rexroth AG | Tightening Technology 7 Data Services7.5 Printer communication7.5.2.1 Interface selection⇒ Set the (SR232) interface here you want to use to send the data over to the receiving device. Youmay only select interfaces that are equipped and not currently being used by other services 1) .7.5.2.2 Print output⇒Use the print output section to set which results should be output. In the Off setting, results outputis inactive, i. e. no results will be output. This setting does not influence the results output via otherdata services.7.5.2.3 Output formatsFormats identical to those for “Results output via FTP” are available for results output (see page 91). Selectthe suitable format for your application.7.5.2.4 Protocol elements of the outputOutput of protocol elements via printer communication is identical to output via Ethernet. A descriptioncan be found under “Protocol elements of output” from page 91.7.5.2.5 Tightening results from several steps in a tightening processOutput of tightening results via printer communication is identical to output via Ethernet. A descriptioncan be found under “Tightening results from several steps in a tightening process” from page 96.7.5.2.6 Standard Plus 310 output formatOutput in the Standard Plus 310 output format for printer communication is identical to output via Ethernet.A description can be found under “Standard Plus 310 output format” from page 101.7.5.2.7 Standard 350 output formatOutput in the Standard Plus 350 output format for printer communication is identical to output via Ethernet.A description can be found under “Standard 350 output format” from page 97.1) Interface selection is done with the operating system, but also by correctly wiring the interface plug.Only one standard (RS232, RS422, 20 mA) may be active per interface.System 350 | 3 608 878 040/05.2008