Rexroth Tightening System 350 System Documentation - Rhino ...

8 Basic Commissioning Tightening Technology | Bosch Rexroth AG 181/3168.5 Operating the Compact System2. All the interface fields are closed by double clicking on .Figure 8–5:View of the interfaces in the Compact System8.5.2.2 Completing the tightening channel configurationWARNING!Incorrect channel configurationAn incorrectly configured ErgoSpin VarioLine or pistolgrip nutrunner may result in faulty tightenings.⇒ When working with the ErgoSpin VarioLine or pistolgrip nutrunner, always check that the componentsstored on the hand-held nutrunner correspond to the actual equipped components and, ifnecessary, correct the configuration with the operating program.To delete a component:⇒ Click on the appropriate symbol in the configuration sequence and press the [Del] button to deletethe component.To add a component:⇒ Add a permitted component (displayed in black) (see page 189).A distinction is made between two cases:– If the new component is to be added to an empty field then select the empty symbol field inthe configuration sequence and add a permitted component (=displayed in black) from the componentselection into the configuration sequence.– If the new component is to be added between two components, select the symbol field in theconfiguration sequence before the place where a new component will be added and select thepermitted (=displayed in black) component from the component selection.Configuration with standard versionIf the tightening channel only contains mechanical components, e.g. an additional drive component onthe ErgoSpin VarioLine, they are inserted in the configuration sequence, but not parameterized. They aretherefore highlighted in red and the message Check component ______ Set parameters is displayed.System 350 | 3 608 878 040/05.2008