Rexroth Tightening System 350 System Documentation - Rhino ...

52/316 Bosch Rexroth AG | Tightening Technology 5 Construction Guidelines5.4 Compatibility with foreign mattersEach connection cable may also be used as an extension. Up to five connection cables can be pluggedin a row.CAUTIONDanger of injury due to high electric voltage and loss of functional and systemreliabilityIf the cables between the Compact System CS351E-D or CS351E-G and the ErgoSpin are too long,this may trigger the residual-current-operated protective device. This can affect the functional andsystem reliability of the tightening system.⇒ For 110/120 V operation, use cables with max. 15 meters in length.⇒ For 230 V operation, use cables with max. 25 meters in length.⇒ Lay the cables so that no one can trip over them.⇒ Observe the minimum bending radius of 130 mm.You can adjust the cable outlet on the right angle plug, e.g. to adapt it to your use. Observe the angle ofturn of the plug, as shown in the following figure.Figure 5–8:Cable outlet on the right angle plug5.4 Compatibility with foreign matters5.5 Planning assistanceAll Rexroth Tightening System components are developed and tested according to the state-of-the-arttechnology.As it is impossible to follow the continuing development of all materials (e.g. lubricants in machine tools)which may interact with our Tightening System components, it cannot be completely ruled out that anyreactions with the materials used by Bosch Rexroth might occur.For this reason, before using the respective material a compatibility test has to be carried out for new lubricants,cleaning agents etc. and our housings/our materials.Partserver is an Internet service that can be used to call up CAN data from many manufacturers. UsingPartserver you can e.g. call up the constructional drawings for hand-held nutrunners or other parts in theTightening System 350. In this manner, you can take over these parts in your CAD without having to redesignanything and put systems together with them.All CAD data from Bosch Rexroth is available free of charge. You can find the respective pages in theInternet at: http://www.boschrexroth.com/schraubtechnik under 3-D/CAD data.System 350 | 3 608 878 040/05.2008