Rexroth Tightening System 350 System Documentation - Rhino ...

82/316 Bosch Rexroth AG | Tightening Technology 7 Data Services7.1 Overview of the tightening results communicationNoteThe entries in the table reflect the condition upon delivery. The table can be changed in the BS350 operatingsystem and transferred to the Compact System.7.1.5 Chronological sequence of the tightening results data7.1.5.1 ID code processingID codes are used if they are available before the start of the tightening (CH x.y Cw or CH x.y CCw).Preparation of ID codes for results is described on page 89.(1)(A)(2)(3)(B)(4)(5)HCH x.y CwCH x.y lnCyCH x.y CyCmpLHLHLHCH x.y ResRsLtFigure 7–3:Chronological sequence of ID code processing with a tightening(A)Tightening(B)ID code (ID code file available in the mass storage)CH x.y Cw StartCH x.y InCy Tightening activeCH x.y CyCmp Sequence endCH x.y ResRs Result reset(1) Cycle(2) Sequence(3) Result processing(4) ID code taken over by the controller (ID code will be deleted if set in the operatingsystem)(5) ID code deletedID codes are deleted if:– the Delete ID code after start setting has been activated in the BS350 operating system or– if the CH x.y ResRs signal has been set by the partner controller.System 350 | 3 608 878 040/05.2008