Rexroth Tightening System 350 System Documentation - Rhino ...

10 Working with the System Tightening Technology | Bosch Rexroth AG 281/31610.2 Settings with the TFT displayFigure 10–44: OK/NOK counterA counter record can either be assigned to the appropriate tightening program or be selected via PLCsignals CntSel 0-5. A total of 48 counter records are available.A counter record is selected with the associated button, which opens the key pad (see page 268). If thecounter configuration is selected via the program selection (Program_1 - Program_3) (see BS350System → OK/NOK counter configuration), the program name will be displayed to the right of the button(Fig. 10–44).The standard values for the OK/NOK counter can only be changed if the user is logged on (see also “Enteringthe PIN” on page 269). The appropriate standard value can then be changed via the associatedbutton, which opens the key pad. The value range for the counter is 0 to 999.Both counter values are reset with the Reset counter button.10.2.6.3 TFT display configurationThree parameters are set here (Fig. 10–45):– Language (in accordance with the loaded language pack)– System display brightness– Shut-down time – time until screen saver mode is activated.Figure 10–45: TFT display configurationThe language is selected with the selection list. Brightness and shut-down time are set with a slider control.It can be used to set the shut-down time in 5-minute increments.To change the PIN via the BS350:Changing the PINOnly the system administrator can change the PIN in the BS350 under Administration → Password administration.Any 4 to 6-digit series of numbers can be used as the HMI PIN (Human Machine InterfacePIN).System 350 | 3 608 878 040/05.2008