Rexroth Tightening System 350 System Documentation - Rhino ...

8 Basic Commissioning Tightening Technology | Bosch Rexroth AG 197/3168.6 Operating the ErgoSpin hand-held nutrunnerFigure 8–21:Selecting the tightening program in the BS350Program selection can take place via 24 V signals (IM24V interface module), a field bus (IMpdp or IMdevinterface module) or, with the CS351E-G, directly via the TFT.NoteThe PLC assignment table must be configured for this accordingly.If no program is selected via one of these interfaces, program 0 is selected as standard. Loosening program99 is set via a CW/CCW reversal switch.If the tightening programs stored in the ErgoSpin are to be automatically loaded in the tightening controller(e.g. when the ErgoSpin is exchanged), the additional function Use tightening programs from handheldnutrunner (program 99 and 0 to 3) must be activated in the channel configuration (see also “Additionalfunctionality” on page 184 and Chapter “Storing the tightening programs” on page 195).NoteIf deviating tightening programs (0 to 3, 99) are already on the tightening controller, they will be overwrittenafter acknowledgement of error message code 382 if the additional function Use tightening programsfrom hand-held nutrunner (program 99 and 0 to 3) (see page 184) is activated.In the BS350, the Data → ErgoSpin tightening programs menu item can be used to compare the tighteningprograms in the tightening controller and hand-held nutrunner. Different programs are highlightedin red (see Figure 8–22):System 350 | 3 608 878 040/05.2008