Rexroth Tightening System 350 System Documentation - Rhino ...

172/316 Bosch Rexroth AG | Tightening Technology 8 Basic Commissioning8.1 Overview8.1 Overview8.1.1 General informationCAUTIONIncorrect connections and open slotsIncorrect cable connections and open slots may lead to damage to the system and injuries.⇒ Always connect all cables correctly and completely before switching the system on.⇒ Close all free slots with dummy panels.The current firmware is installed on all components on delivery.When exchanging these components or purchasing complementary ones, please pay attention to thecompatibility of the firmware 1) ! In the BS350, the current firmware versions for the components used aredisplayed under System test → Info tightening cell → Firmware.NoteBefore commissioning, check if a new service pack is available in the download section 2) underhttp://www.boschrexroth.com/tightening. You can also find further information there on:– Service packs for older versions (if available)– Current firmware updates– Further information on upgrading/downgrading different versions in the Rexroth TighteningSystem 350.NoteA description on how to use the firmware updates and service packs can be found under “Full versionand service packs” on page 247!1) The firmware for the CS351 Compact System and BS350 must have the same release version. TheErgoSpin may have a firmware state that varies from the tightening controller.2 http://www.boschrexroth.com/business_units/brc/en/information_en/software_en/download_se_en/firm_allg/index.jspSystem 350 | 3 608 878 040/05.2008