Rexroth Tightening System 350 System Documentation - Rhino ...

OKNOK191781624FGC1C3C2CS351174/316 Bosch Rexroth AG | Tightening Technology 8 Basic Commissioning8.3 Connecting the PC to program the tightening system8.2.3 Connecting to the Compact SystemTo connect the ErgoSpin hand-held nutrunner to the Compact System:1. Insert the socket for the ErgoSpin connection cable in the plug on the handle of the hand-held nutrunner(use the guide grooves and catches) and tighten the union nut connection firmly by hand.2. Insert the plug for the nutrunner connection cable in the XDS1 spindle connection interface on theCompact System and tighten the union nut connection firmly by hand.8.3 Connecting the PC to program the tightening system8.3.1 Connecting the PCThe tightening system is programmed via a connected PC with installed BS350 operating software. Thefollowing interfaces may be used to connect the PC as seen in Figure 8–2:RexrothUSB interface X3U3C5 C4Ethernet interface X7E1Figure 8–2:PC interfacesConnecting to the Ethernet interfaceIn order to operate the tightening system via Ethernet, the PC has to be equipped with an Ethernet interfacecard for network operation.NoteDetailed information on setting up Ethernet interfaces can be found under “Setting up the Ethernet interfaceon the PC and tightening system” on page 247!8.3.2 Installing the BS350 operating system on the PCWindows 2000 or Windows XP (including the latest service pack) and at least Windows Installer 3.1 arerequired to install the BS350. Installation under Windows NT is not possible.System 350 | 3 608 878 040/05.2008