Rexroth Tightening System 350 System Documentation - Rhino ...

176/316 Bosch Rexroth AG | Tightening Technology 8 Basic Commissioning8.3 Connecting the PC to program the tightening system2. In the BS350 operating system, click on System → Tightening channel configuration.3. Double click on the line CS to view the interfaces.4. Double click on the line X7E1.The Compact System X7E1 parameter dialog will appear (see page 184).5. Enter the desired data to configure the Ethernet interface.6. Click on Accept to accept the data and close the parameter dialog.7. Click on Data → Send to send the modified data to the controller.To select the Ethernet interface:1. Click on PC → Interface.2. Select the Ethernet interface.3. Enter the new IP address under Tightening cell.4. Click on OK to accept the settings.5. Click on System test → Tightening channel info to test the connection.8.3.5 Logging onto the tightening system (password entry)In order to be able to change tightening programs and configurations, the user must be logged onto thetightening system under his user name and password.NoteThe user does not have to be logged onto the system to call up configurations, results, error lists, etc.To log onto the tightening system:1. Click on the symbol orclick on Administration → Log ON/OFF orPress the [F3] button on the keyboard.2. Enter the password Robert and confirm with OK.Figure 8–3:User name Bosch, password RobertThe status Log ON is shown in the status bar.Note Information on changing the password can be found under “User administration” on page 250!System 350 | 3 608 878 040/05.2008