Rexroth Tightening System 350 System Documentation - Rhino ...

50/316 Bosch Rexroth AG | Tightening Technology 5 Construction Guidelines5.3 Integration of the tightening system in an installation5.3.7.2 Program selectorThe program selector is used to select the appropriate tightening program for hand-held nutrunners:Figure 5–6:Example of program selectorThe program selector is available in three versions:– with 12 programs: program 0-11– with 16 programs: program 0-15– with 48 programs: program 0-47By connecting to a 24 V interface (IM24V), the appropriate input signal will be set at the interface dependingon the position of the switch. Here, the four inputs 0.0 to 0.3 are used as a 4-bit word. Programselection can thus take place by assigning the program selection bits Prog0 to Prog3 in the PLC table.5.3.7.3 Connection adapter for program selector and socket trayYou can use a connection adapter to connect the program selector or the socket tray to the CompactSystem. The adapter itself has only one connection, but has an additional reserve (e.g. for Profibus) oftwo cables, 8 mm diameter.5.3.7.4 Tool mountsSelecting the suitable output drive also includes finding the appropriate tool mount. Output drives areavailable with various tool mounts. Special output drives can be manufactured as required.The following tool mounts must be differentiated:– Square drive– Quick-change chuck– Square with play-free toothingSystem 350 | 3 608 878 040/05.2008