Rexroth Tightening System 350 System Documentation - Rhino ...

7 Data Services Tightening Technology | Bosch Rexroth AG 95/3167.2 Ethernet communicationTable 7–6: List of switch-off criteriaIndex Process stopped by tightening controller7 Target function Input8 MFs * Angle too high9 MFs * Torque too high10 MFs * Torque too low11 MFs * Gradient too high12 MFs * Gradient too low13 MFs * Time too high14 MFs * Gradient drop15 Remove Cw start signal16 Remove CCw start signal17 Remove En enable signal18 System error19 Sync step20 Rework step21 NOK branch step22 Target function Gradient23 Target function Upper torque24 Target function Upper relative torque25 Target function Lower torque26 Target function Lower relative torque27 Monitoring function Torque, final value too high28 Monitoring function Torque, final value too low29 Monitoring function Torque, final relative value too high30 Monitoring function Torque, final relative value too low31 Monitoring function Torque, max. value too high32 Monitoring function Torque, min. value too low33 Monitoring function Stick slip too high34 Monitoring function Global angle too high35 Monitoring function Global angle too low* Monitoring function switchingDescription of the quality codes (QC)The quality code describes whether a tightening was evaluated with OK or NOK. If an NOK evaluation isoutput, the cause will also be listed.Table 7–7: Quality codes and descriptions (section 1 of 2)Quality code Monitoring function NOK * All other monitoring functions Category1 – All OK System2 A+, OK All4 A-, OK All8 T+, OK All10 A+, T+, OK All12 A-, T+, OK All16 T-, OK All18 A+, T-, OK All20 A-, T-, OK AllSystem 350 | 3 608 878 040/05.2008