Rexroth Tightening System 350 System Documentation - Rhino ...

7 Data Services Tightening Technology | Bosch Rexroth AG 133/3167.3 3964R communicationTable 7–23: Number of digits before and after the decimal point for measurement values (internal floating decimal point display)Measurement/limit valuesNumber of digits beforedecimalNumber of digits after decimalTorque * T MaxSpindle < 10 Nm 1 3T MaxSpindle < 100 Nm 2 2T MaxSpindle < 1000 Nm 3 1T MaxSpindle ≥ 1000 Nm 4 0 (no decimal!)Gradient * T MaxSpindle < 10 Nm 0 4T MaxSpindle < 100 Nm 1 3T MaxSpindle < 1000 Nm 2 2T MaxSpindle ≥ 1000 Nm 3 1Angle A < 10 degrees 1 2A < 100 degrees 2 2A < 1000 degrees 3 2A < 10000 degrees 4 2A < 100000 degrees 5 2Time t < 10 s 1 2t < 100 s 2 2t < 1000 s 3 2t < 10000 s 4 2* The number of digits before and after the decimal point for the torque and gradient depends on the maximumtorque for the tightening spindle.ExampleES065G hand-held nutrunner with a maximum permitted output drive torque of 65 Nm. The set and actualvalues for the torque are listed with 2 digits before and 2 after the decimal point, e.g. _4.00 or 16.23or even _0.17.Outputting measurement values as floating decimal points (ASCII)The internal measurement values are still output as a character sequence. The decimal character is outputas a decimal point. This output always includes 8 characters (bytes).Table 7–24: Number of digits before and after the decimal point for measurement values (ASCII)Measurement/limit valuesNumber of digitsbefore decimalNumber of digits afterdecimalData element numberdisplay in ASCII formatTorque ** T MaxSpindle < 10 Nm 1 3 ___x.xxxT MaxSpindle < 100 Nm 2 2 __xx.xx_T MaxSpindle < 1000 Nm 3 1 _xxx.x__T MaxSpindle ≥ 1000 Nm 4 0 (no decimal!) xxxx____Gradient ** T MaxSpindle < 10 Nm 0 4 ___.xxxxT MaxSpindle < 100 Nm 1 3 ___x.xxxT MaxSpindle < 1000 Nm 2 2 __xx.xx_T MaxSpindle ≥ 1000 Nm 3 1 _xxx.x__Angle A < 10 degrees 1 2 ____x.xxA < 100 degrees 2 2 ___xx.xxA < 1000 degrees 3 2 __xxx.xxA < 10000 degrees 4 2 _xxxx.xxA < 100000 degrees 5 2 xxxxx.xxSystem 350 | 3 608 878 040/05.2008