Rexroth Tightening System 350 System Documentation - Rhino ...

254/316 Bosch Rexroth AG | Tightening Technology 10 Working with the System10.1 Settings in the BS350Table 10–2: Quality codes and their meanings (section 2 of 2)Quality code Monitoring function NOK All other monitoring functions Category18 A+, T–, OK All20 A–, T–, OK All32 G+, OK All34 A+, G+, OK All36 A–, G+, OK All40 T+, G+, OK All42 A+, T+, G+, OK All44 A–, T+, G+, OK All48 T–, G+, OK All50 A+, T–, G+, OK All52 A–, T–, G+, OK All64 G–, OK All66 A+, G–, OK All68 A–, G–, OK All72 T+, G–, OK All74 A+, T+, G–, OK All76 A–, T+, G–, OK All80 T–, G–, OK All82 A+, T–, G–, OK All84 A–, T–, G–, OK All128 NOK OK/NOK System129 System error (fault) OK/NOK System130 Remove start signal ((C)Cw = 0) OK/NOK System130 Remove enable (En = 0) OK/NOK System131 Timeout sync/rework (t+ Sync/RW) OK/NOK System131 Timeout application (t+ app) OK/NOK System132 Synchronization (Sync) OK/NOK System133 Rework (RW) OK/NOK System136 NOK step (max. NOK)137 Redundancy torque (RedT) OK/NOK System138 Redundancy angle (RedA) OK/NOK System139 Start-up test (StartUp) OK/NOK SystemExampleA+, T–, G+ means upper limit of angle, lower limit of torque and upper limit of gradient has been exceeded.Category of the tightening stepStandard tightening steps and extended tightening steps can be assigned to one of ten categories (seepage 212). A quality code can be linked to one or more categories when creating/changing the entriesin the quality code assignment table. A quality code is then only output if the tightening step that providedthe NOK result is also from the correct category.The entries in the standard quality code assignment table are either assigned to the System category(= intrasystem) or all categories (= All). New entries can only be explicitly assigned to the categories thatcan be set for a tightening step.Order of the entriesThe table is searched from top to bottom when selecting the quality code. The order of the entries is thusdecisive for the selection of the quality code.System 350 | 3 608 878 040/05.2008