Rexroth Tightening System 350 System Documentation - Rhino ...

296/316 Bosch Rexroth AG | Tightening Technology 10 Working with the System10.4 Results storage and statisticsTo change the configuration currently in use:⇒ In the BS350 operating system, click on System → Results storage configuration.In all cases, the configuration window opens as shown below (Fig. 10–58).Figure 10–58: Results storage configurationThe Results storage configuration window consists of 3 group fields:– Results selection– Program selection– Storage characteristicsResults selectionThe available values (Available) in the left window (Fig. 10–58 on page 296) can be filtered from the listbox.The following selections are available:– *: List of all available values– General: List of general, tightening-related data– Actual values: List of the actual values for the four documentation steps– Set values: List of the set values for the four documentation steps– Result step (0): List of the values for the result step– Docu buffer 1 (1): List of the result values for the docu buffer 1– Docu buffer 2 (2): List of the result values for the docu buffer 2– Docu buffer 3 (3): List of the result values for the docu buffer 3Result, c. no. SE and Program in the right window are already selected as standard entries and cannotbe deselected (shown gray). Added values are shown black and can be deselected.To specify results storage for one value:1. Select value in the left window (Available).2. Click the following button:the value is taken over (Selected) in the right window and shows up gray in the left window.To deselect values, proceed in the opposite direction.For the tightening parameters (e.g. T + ) an explanation is shown if the mouse is held briefly over the abbreviation.System 350 | 3 608 878 040/05.2008