Rexroth Tightening System 350 System Documentation - Rhino ...

7 Data Services Tightening Technology | Bosch Rexroth AG 139/3167.3 3964R communication(2) Sequence(3) Result processing(4) ID code taken over by the controller (ID code will be deleted if set in the operating system)(5) Result invalidID codes are deleted if:– The Delete ID code after start setting has been activated in the BS350 operating systemor– if the CH x.y ResRs signal has been set by the partner controller.It is always recommended that an ID code is deleted if it is no longer needed, e.g. if the workpiece hasleft the station or a new workpiece has come in.ID codes that have not been deleted will be reused.Note If active, the ID code will be extended with a sequence number (see page 86).Note You can find a detailed list of the actual PLC signals in chapter 6, “Control Signals” on page 55.7.3.5.2 Transferring results data with the 3964R or RK512 protocolsNote Further time sequences can be found in chapter 6, “Control Signals” from page 55.(1)(A)(2) (3)(B) (4) (5)Ch x.y CwCh x.y InCyCh x.y CyCmpCh x.y OkHLHLHLHLtFigure 7–36:Time sequence for preparing and transferring the tightening results from a tightening with the 3964R protocolSystem 350 | 3 608 878 040/05.2008