Rexroth Tightening System 350 System Documentation - Rhino ...

182/316 Bosch Rexroth AG | Tightening Technology 8 Basic Commissioning8.5 Operating the Compact SystemConfiguration with an adapter, spindle bearing, or angle head1. Double click on the field highlighted in red to open the associated parameter dialog.Figure 8–6 shows the adapter entry window after double clicking in the red field in line A.Figure 8–6:Complete the configuration with the special component entry window2. Select the components to be used from the Code drop-down list (note the sizes).A serial number does not need to be entered for mechanical components.Efficiency is used to calculate the output torque. Nominal efficiency is automatically entered for thecorresponding component by the BS350, but it can be adjusted up or down as needed (e.g. if thereare signs of wear).3. Click on Accept to accept the component data in the program. The data is then displayed in white.The assignment of parameters is aborted and any modifications are rejected by selecting Cancel.4. If necessary, set the missing parameters for further components.NoteAll the values in the parameter fields should be compared with the data on the nameplates for accuracy!To correct these values, double click on the respective parameter field, then correct and transfer the datato the configuration.As an alternative, you can also delete the component (see above). You then add another component, suchas an angle head or adapter on a stationary spindle, for the ErgoSpin VarioLine. Also set the missing parametersfor this component as described above.Configuration without standard versionAdditional, special mechanical components can be added to the ErgoSpin ESM and ESV hand-held nutrunners.After you have added them, the components can be selected from the database or freely configured.1. If necessary, delete an existing component.2. Add a new component.3. Double click on the field highlighted in red to open the associated parameter dialog.Figure 8–6 shows the special component entry window after double clicking on the line SO.System 350 | 3 608 878 040/05.2008