Rexroth Tightening System 350 System Documentation - Rhino ...

8 Basic Commissioning Tightening Technology | Bosch Rexroth AG 185/3168.5 Operating the Compact SystemFigure 8–9:Parameter dialog X7E1You can make the following settings in the Ethernet interface setup field:– IP address: Assigned by the network administrator; identifies the participant in the data exchange.– Subnet mask: Assigned by the network administrator; contains information on the network configuration(address range).– Host name: Name by which the Ethernet participant (here the Compact System) can be addressed.– DNS: Assignment of logical participant names to unique IP addresses.– Domain name: The domain name is the same for all the participants in an Ethernet, the full logicalname of a participant is Hostname@Domainname.– Gateway: Establishes the external connection.NoteDetailed information on data exchange via Ethernet can be found under “Ethernet communication” onpage 83.⇒Click on Accept to store this data in the program.8.5.2.5 Setting up additional interfacesA slot interface (A)This interface is intended for inserting type A interface modules from Rexroth. A tightening system is controlledby this interface. It enables cyclical data exchange via the following interface modules:– IMpdp– IMdevThe associated parameter dialog is opened by double clicking on the parameter field in line A (see Figure8–5).⇒In the Select interface module field (see Figure 8–10), select the desired module from the dropdownlist and set its parameters.System 350 | 3 608 878 040/05.2008