Metric Tutorials - Autodesk

5 In the Filter dialog, do the following:
■ Click Check None.
■ Select Structural Columns.
■ Click OK.
6 On the Options Bar, click .
7 In the Element Properties dialog:
■ Under Constraints, enter 0 mm for Base Offset.
■ Under Analytical Model, select Level 2 for Top Vertical Projection.
■ Under Analytical Model, select Ground Level for Bottom Vertical Projection.
■ Click OK.
8 In the Project Browser, under Structural Plans, double-click Ground Level.
9 On the Modelling tab of the Design Bar, click Foundation ➤ Isolated.
10 In the Type Selector, select M_Footing-Rectangular:1800x1200x450 mm.
11 In the drawing area, click the midpoints of the columns where you have added horizontal
framing to place an isolated footing at each location.
NOTE In the following image, the curtain wall visibility was altered for training purposes. In your
training file, the imported DWG file does not display in this view.
By default, the footing is placed at Ground Level.
12 On the Design Bar, click Modify.
Adding Isolated Foundations | 153