Metric Tutorials - Autodesk

Notice that the area reinforcement is represented with a special symbol that indicates the
approximate location of the reinforcement in the concrete wall.
25 Click File menu ➤ Save As.
26 Navigate to a folder of your preference, and save the file as m_RST_EW_Detailing.rvt.
27 Proceed to the next exercise, Placing Stirrup Rebar (Parallel) on page 52.
Placing Stirrup Rebar (Parallel)
In this exercise, you place stirrup rebar in a cross section view. The rebar is placed parallel to the exterior
face of the concrete beam.
Training File
Continue to use the project training file saved in the previous exercise, m_RST_EW_Detailing.rvt.
Create a section view
52 | Chapter 2 Express Workshops
1 In the Project Browser, under Structural Plans, double-click Level 2.
2 On the Toolbar, click , and draw a zoom box around the southeast corner of the structure.
3 On the View tab of the Design Bar, click Section.
4 Click inside the wall between grid lines 4 and 6, move the cursor down, and click outside the
south wall to place the section.