Metric Tutorials - Autodesk

NOTE The 2 short lines adjacent to the vertical line of the outline represent the rebar major direction.
Bars will be placed parallel to the major direction near both wall faces. Minor bars will be placed
perpendicular (inside position) to the major bars (outside position), adjacent to the major bars. To
change the major direction, on the Design Bar, click Major Direction Edge, and select one of the
horizontal lines of the outline.
13 On the Design Bar, click Finish Sketch.
The area reinforcement is automatically applied to the selected foundation wall, and is indicated
on the 3D view with an X as shown.
14 In the Project Browser, under Sections (Building Sections), double-click Section 3.
332 | Chapter 10 Concrete Reinforcement Modelling