Metric Tutorials - Autodesk

22 In the Element Properties dialog:
■ Under Constraints, for z-Direction Justification, select Other.
■ Under Constraints, for z-Direction Offset Value, enter -400 mm.
■ Click OK.
23 Add cantilever beams and outriggers to complete the new corner.
Extend the shaft to roof level
24 In the Project Browser, under Structural Plans, double-click Level 2.
25 Zoom around the stairway in grid location F3-G4.
26 Select the 4 walls surrounding the stairwell.
27 On the Options Bar, click .
28 In the Element Properties dialog, under Constraints, do the following:
■ For Top Constraint, select Up to level: Roof.
■ Click OK.
Copy roof framing and slab to Level 6 and 7
29 In the Project Browser, under Structural Plans, double-click Level 5.
30 Zoom out until you can see the entire model within the drawing area.
31 Draw a pick box around the entire model.
32 On the Options Bar, click .
170 | Chapter 5 Creating a Structural Model