Metric Tutorials - Autodesk

NOTE For training purposes, the tags that were placed in the previous steps have been removed
from this view.
5 On the Design Bar, click Beam Annotations.
6 In the Beam Annotations dialog, do the following:
■ Under Placement, select All selected beams in current plan view, and click Remove existing
beam tags and spot elevations.
■ Click Settings.
■ In the Placement Settings dialog, for Horizontal End Offset, enter 60 mm, and click OK.
This dimension sets the annotation offset distance measured from the beam start location
as indicated in the dialog.
■ Under Annotation location and type, click the Level beams in plan tab.
■ Click , to specify the top-end annotation type as shown.
■ In the Select Annotation Type dialog, under Select Element to Place, click Structural Framing
Tag.
■ Under Structural Framing Tag, select M_Structural Framing Tag-w-End Reactions : Standard,
and click OK.
394 | Chapter 11 Annotating and Dimensioning