Metric Tutorials - Autodesk

Label the angles and the plate
29 On the Drafting tab of the Design Bar, click Text.
30 On the Options Bar, click .
31 Draw a text leader to the plate, and enter 9 mm for text.
32 On the Drafting tab of the Design Bar, click Text.
33 On the Options Bar, click .
34 Draw a leader to the brace and enter L205x205, TYPICAL for text as shown.
35 Click File menu ➤ Save.
36 Proceed to the next exercise, Creating a Bolted Angle Detail on page 305.
Creating a Bolted Angle Detail
Training File
Continue to use the training file you saved in the previous exercise, m_RST_DET-in progress.rvt.
In the first part of the exercise, you add 2 angles to the model using an angle family that has been loaded
into the project. Then you add some annotations.
Creating a Bolted Angle Detail | 305