Metric Tutorials - Autodesk

NOTE You can open or close the Rebar Shape Browser by clicking on the Options Bar. For training
purposes, the Rebar Shape Library is already loaded in this training file. The library is located in the
Rebar Shapes folder in the Metric Library.
Place rebar parallel to the column face
Set rebar spacing
4 In the Type Selector, select Rebar Bar: 10M.
5 Click in the Rebar Shape Browser, scroll down the list of available shapes, and select Rebar Shape:
M_T1.
6 Hover over the section view.
Notice that the rebar shape changes as you select a different column edge.
7 Click the bottom edge of the column to place the rebar as shown.
8 On the Design Bar, click Modify.
9 Select the rebar that you just placed, and on the Options Bar, do the following:
■ For Rebar Size, select Rebar Bar: 10M.
■ For Layout, select Maximum Spacing.
■ For Spacing, enter 100.
324 | Chapter 10 Concrete Reinforcement Modelling