Metric Tutorials - Autodesk

The Activate View command activates a viewport on the sheet, allowing you to edit the model
directly from the sheet.
3 On the Drafting tab of the Design Bar, click Tag ➤ Tag By Category.
4 On the Options Bar, clear Leader.
5 In the drawing area, position the cursor just outside the revision cloud for grid line B.
If the cursor is just inside the cloud, the tag is displayed inside the cloud.
6 Click to place the tag.
The tag displays the revision number of the cloud. The number is based on the numbering
method you specified when you set up the revision table. Because you chose to number by sheet,
and because the revision is the first in the project, the cloud is tagged as number 1.
7 Repeat steps 2 through 5 to add revision tags for all remaining revision clouds.
8 Click File menu ➤ Save.
Working with Revisions
9 Proceed to the next exercise, Working with Revisions on page 447.
In this exercise, you first view the revisions that were created in the previous exercise, and then issue the
revisions to create a record, and lock it from further changes.
NOTE This exercise requires the completion of the previous exercise. Use the project file that you saved at the
end of that exercise, m_RST_Revision-in progress.rvt.
View the revisions
1 In the Project Browser, under Sheets (all), double-click S.1 - Level 3 Framing Plan.
2 Select , and draw a zoom box around the title block as shown.
Working with Revisions | 447