Metric Tutorials - Autodesk

17 With the view selected, right-click, and click Element Properties.
18 In the Element Properties dialog box, under Graphics, specify 1:200 for View Scale, and click
OK.
The scale of the view on the sheet changes. If you were to open the Structural Plan: Level 2,
right-click, and click View Properties, you would see that the scale plan view is now 1:200.
19 Drag the view to the upper-left corner of the sheet.
20 Adjust the length of the title line by selecting the view, and dragging the right end control until
it fits under the view.
NOTE If necessary, you can select the view title separately and move it to a new position.
Add an elevation to the sheet
21 On the View tab of the Design Bar, click Add View.
22 In the Views dialog box, select Elevation: South Elevation, and click Add View to Sheet.
23 Click on the lower half of the sheet to place the view.
24 With the view selected, right-click, and click Element Properties.
25 In the Element Properties dialog, do the following:
■ Under Graphics, specify 1:200 for View Scale.
■ Under Extents, clear Crop View.
■ Click OK.
244 | Chapter 7 Creating Drawings
26 Position the view below the Structural Plan: Level 2.
27 Drag the title line under the elevation view.
28 Adjust the length of the title line by selecting the view, and dragging the right end control until
it fits under the view.