Metric Tutorials - Autodesk

Add a revision cloud for the door interference
29 In the Project Browser, under Sheets (all), double-click S.2 - Stair Shafts Sections.
30 Right-click the right view on the sheet, and select Activate View.
The Activate View command activates a viewport on the sheet, allowing you to edit the model
directly from the sheet.
31 On the Drafting tab of the Design Bar, click Revision Cloud.
Revit Structure is now in sketch mode.
32 In the drawing area, click above the door, and move the cursor clockwise to create a segment
of the revision cloud.
33 Click to end that segment and begin a new segment.
34 Continue adding segments until the cloud encompasses the area that you changed.
35 On the Design Bar, click Finish Sketch.
The revision cloud is displayed around the door. You can change the appearance of the cloud
from the Settings menu.
36 Click File menu ➤ Save.
Tagging Revision Clouds
37 Proceed to the next exercise, Tagging Revision Clouds on page 446.
In this exercise, you apply a revision tag to the revision cloud in the current drawing. The tag number that
is displayed in the drawing is based on the numbering method you specified when you set up the revision
table in a previous exercise.
NOTE This exercise requires the completion of the previous exercise. Use the project file that you saved at the
end of that exercise, m_RST_Revision-in progress.rvt.
Place a revision tag
446 | Chapter 13 Project Coordination
1 In the Project Browser, under Sheets (all), double-click S.1 - Level 3 Framing Plan.
2 Right-click the view on the sheet, and select Activate View.