Metric Tutorials - Autodesk

The area reinforcement for the slab is displayed.
Change the area reinforcement properties
Change bar type
Add annotation
14 Select the area reinforcement.
Notice the graphical controls to toggle the hook orientation appear at each end of the area
reinforcement.
15 On the Options Bar, click .
16 In the Element Properties dialog, under Layers, clear Top Major Direction, and click OK.
Notice the bars in the top major direction are deleted from the section view.
17 On the Options Bar, click .
18 In the Element Properties dialog, under Layers, change all Bar Types to 13M, and click OK.
19 On the Design Bar, click Modify.
20 On the Drafting tab of the Design Bar, click Tag ➤ By Category.
21 Click the area reinforcement to place the tag.
22 On the Design Bar, click Modify.
23 Select the rebar tag, and on the Options Bar, select Attached End.
24 Using the drag control, move the rebar tag approximately as shown.
Area Reinforcement in a Slab | 341