Metric Tutorials - Autodesk

60 After aligning the beam, click the padlock that displays to lock the alignment.
61 On the Design Bar, click Modify.
62 Select the beam and, on the Edit toolbar, click .
63 On the Options Bar:
■ Clear Group and Associate
■ Enter 4 for number
■ Select 2nd for Move To:
■ Select Constrain
Using the Array tool requires two clicks. The first click sets the move start point. The second
click represents the move end point.
64 Click the start point at the alignment of the beam and wall as shown.
65 Move the cursor down to the next intersection of the lower edge of the horizontal wall and the
beam. Click to indicate the end point of the move.
600 | Chapter 19 Creating Multiple Design Options