Metric Tutorials - Autodesk

■ In the left pane of the Open dialog, click Training Files, and open Metric\m_RST_CSM_4.rvt.
In this training file, additional cantilever beams and outriggers were added to the model. In addition, the
following new levels were added: 5, 6, 7, Roof, Garage Level-1, and Foundation. The pre-existing columns
were paste-aligned to the roof level.
Add concrete slab with metal deck
1 In the Project Browser, under Structural Plans, double-click Level 2.
2 On the Modelling tab of the Design Bar, click Slab.
3 On the Design Bar, click Floor Properties.
4 In the Element Properties dialog:
■ For Floor Type, select 160mm Concrete with 50 mm Metal Deck.
■ For Height Offset from Level, enter -200 mm.
■ Click OK.
5 On the Design Bar, click Lines.
6 Sketch lines along the structure perimeter using the interior lines of the glazing as snap points.
When sketching this deck, you can use a combination of lines including; sketched, picked,
straight, and arced. Use Trim/Extend to clean up line intersections and close gaps.
Adding a Concrete Slab with Metal Deck | 163