Metric Tutorials - Autodesk

All of the exterior walls of this project are now changed to the new type.
18 On the Design Bar, click Modify.
19 On the View Toolbar, click .
Notice that the foundation walls are no longer gray and there is no material pattern applied in
this view. This is because a surface pattern was not selected when the material was defined. In
the following exercise, Creating and Applying Fill Patterns on page 84, you create a pattern and
apply it to this material.
20 On the Rendering tab of the Design Bar, click Rendering dialog.
TIP If the Rendering tab is not available on the Design Bar, right-click the Design Bar, and select
Rendering.
21 In the drawing area, draw a pick box around the entire 3D image.
NOTE If you want to see the material in greater detail, zoom into the model, and drag a zoom box
around the area you want to render.
22 In the Rendering dialog, do the following:
■ For Quality Setting, select Best.
■ Click Render.
The rendering process begins. When it is finished, the material that you created is displayed.
Creating and Applying Materials | 83