Metric Tutorials - Autodesk

Change bar type
Add annotation
Notice that additional bars are added to the section view.
20 On the Design Bar, click Modify.
21 Select the Area Reinforcement.
22 On the Options Bar, click .
23 In the Element Properties dialog, under Layers, change all Bar Types to 13M, and click OK.
24 Right-click in an empty part of the drawing area, and click Zoom to Fit.
25 On the Drafting tab of the Design Bar, click Tag ➤ By Category.
26 Click the area reinforcement to place the tag.
27 On the Design Bar, click Modify.
28 Using the drag control, move the area reinforcement tag approximately as shown.
336 | Chapter 10 Concrete Reinforcement Modelling