Software Input/Output Guide X11 Administration ... - paulmick.com

Add a data telephone
LD 11
Prompts and responses by task Page 115 of 1050
The following prompts apply to M2006, M2008, M2216, M2616 data ports
(MPDA), DAC card units and Meridian Communications Adapter (MCA)
only:
All operating parameter information is stored in the MPDA. If the hardware
does not exist, the parameter information is lost. The hardware must be
connected before configuring the operating parameters in this program. In the
event that the parameters are lost, it is possible to enter the data through the
data adapter. It is not necessary to re-enter the program.
Prompt Response Comment
REQ: NEW Request = NEW
TYPE: a...a Type of data block (TYPE responses begin on page 174)
TN l s c u Terminal Number (l s c u ranges are defined on
page 173)
CDEN aa Card Density (aa = SD, DD, 4D, or 8D)
DES d...d Office Data Administration System Station Designator
CUST xx Customer number associated with this set
MPHI (NO) YES Meridian Communications Unit used as MPH interface
KLS 1-7 Number of Key/Lamp Strips
AOM 0-2 Number of Add-on Modules
KBA (0)-2 Key-Based Accessory
FDN x...x Flexible CFNA DN
TGAR 0-(1)-31 Trunk Group Access Restriction
LDN aaa Listed Directory Number Index as defined in LD 15
NCOS (0)-99 Network Class of Service group
RNPG (0)-4095 Ringing Number Pickup Group
SSU 0-4095 System Speed call list number
XLST (0)-7 Pretranslation group associated with this station
SCPW xxxx Station Control Password
SGRP (0)-999 Scheduled Access Restriction Group number
ELKP x...x Electronic Lock Password (1-15 digits)
SFLT a...a Secretarial Filtering (a...a = (NO), BOSS, or SEC)
- SFDN xxxx Secretarial Forwarding DN of secretary set
CAC (0)-10 Category Code for CNI of MFC trunks
X11 Administration